Leviton Compact Fluorescent Lamp Holder. Bidirectional lamp holder provided by the fixed end of the casing, pumping core lamp holder, casing cover, the protective net, a reflection plate, glass, etc., characterized in that the two fixed ends of the housing through the protective net is connected into a unitary, is installed on the fixed end housing threading tube and reflector plate, the left end of the flexible plug, core pulling the socket body and rubber seals, rubber seals installed on the right end of the socket body and tube positioning ring, core pulling. High mechanical strength, illumination and reliable anti-minutes can save time, quickly and easily replace the fluorescent tube and Leviton Compact Fluorescent Lamp Holder.
Leviton Compact Fluorescent Lamp Holder manufacturing process of the lamp positioning means of the housing, which comprises the working of the table, under the pressure of components, the controller and the drive, the lower press assembly is provided with the compression structure, the cylinder, the piston, the rack, positioning axis;the lower end of the bench provided fixture; match of said cylinder and piston, the piston with the rack is fixed, said shaft with the rack vertical positioning, positioning axis fixed gear engaging said gear rack, said positioning shaftfixed positioning of head, the positioning head has a two and the cap through hole of the housing end portion matches the positioning pin, said positioning pin with respect to the positioning head can be elastically stretchable; said controller, respectively, with a drive, the compressionThe structure, the cylinder is electrically connected; said drive table drive connection. The utility model using linear cylinder instead of the rotating cylinder, to reduce the the Leviton Compact Fluorescent Lamp Holder manufacturing cost of equipment and manufacturing technology requirements.
All fluorescent light fixtures consist of at least lamp(s), Leviton Compact Fluorescent Lamp Holder, fluorescent ballast and internal wiring. Some older types have “starters”, too. The ballast is used to create the voltage and current necessary to start and illuminate the fluorescent lamp. In time, the ballast may need to be replaced. Read on to learn how to swap out the old with an approved replacement ballast of the same technology. Please read the entire article and warnings before attempting.
The Leviton Compact Fluorescent Lamp Holder continues to grow with the newly introduced T8 series featuring rotary lamp-lock technology and bottom push-in wiring. Our linear fluorescent brochure details the many different mounting, wire insertion and lamp insertion configurations available.
Leviton Compact Fluorescent Lamp Holder, med bi-pin, turn type, dedicated T8, snap-in mounting, 660w-600v. UL and CSA. With internal shunt.
Waterproof moistureproof T8 fluorescent lamp holder, suitable for moisture condensation or shallow water environment. Good insulation properties of rubber or resilient plastics material made ??its one end about 1/2 part of a hollow tubular, the pipe inner diameter is slightly smaller than the corresponding fluorescent tube outside diameter, the length can be formed with the glass portions of the fluorescent tubes partially overlap , inside the other end has a pin jack and pin connectors reed wire. Since the lamp holders sealed elastic material, when the fluorescent tube is inserted into one end of its tubular, i.e. closed state, the other end of the wire leads is also sealed to the elastomeric material wrapped in a sealed state.