What’s the batten lamp holder?

In rural areas, batten lamp holder for ceiling lamps and lighting fixtures, the most of the families used is the wiring lamp head. This kind lamp holders are generally There are two: one is the the batten lamp holder, pick the Bayonet port light bulb; the other is the the batten lamp holder, Mating Thread light bulb. But the Is this two kinds of the lamp cap are not compatible, So inconvenient. The of dual-use lamp holder of I designed to solve the the the problem of of are two light bulb can not be interoperable.

batten lamp holder

This kind dual-use batten lamp holder will the lamp holder of threaded with the Bayonet organically combine to the together: First of all Bayonet lamp holder do not have to changes to and, simply in the the threaded lamp holder connected to the supply the line end of to Add the the mouth end of the a Bayonet , and then on the the on-improve the port two poles of power cord end of carried out, leads to the connect two poles of the on the the two poles of of threaded lamp, the fixed has since become one of there are the threaded lamp holder of Bayonet lamp holder.

There are the threaded of the batten lamp holder card be on the the lamp holder of in the bayonet, connected to the threaded light bulbs you can in the the on the the lamp holder of the bayonet the use of threaded light bulbs; in the pick of when the card mouth light bulb, just put there are the threaded of the Bayonet of the lamp holder to take down the, connected to the card mouth light bulb can, so that both for the convenience to and fast.

I’ve got a camping swag type pendant light fixture which I like to hard cable in to the ceiling. I cut the plug off of the light fixture cord and ” cable ” it straight to the neutral and hot cables within the ceiling fixture recess. I ensured the neutral and hot wires went to the related terminals within the lamp holder. There’s a floor cable within the ceiling recess, I haven’t touched this as my wiring does not have a ground and i’m not sure how to deal with this.

batten lamp holders types

Anyway, while I switch the light on nothing happens. I can check out the very hot wire is energized as my live wire detector beeps when it’s close to it. It beeps all the way down towards the light fixture socket.

Remarks: You need to mention when you first wired this up I had live and neutral corrected within the lamp holder and got a short while I switched it on. I do not think the fuse is blown since I get power and I changed the bulb to ensure the lamp wasn’t blown either.

The first thing to do is test the batten lamp holder itself. The easy way try this is to apply a multi-meter set to AC and an appropriate voltage setting for your supply voltage. Using the test leads, touch the bottom pin and the metal of the base exterior (the part the bulb screws into). It should read your supply voltage. If it does not then there is an issue with the lamp socket itself. If it reads the right voltage, either your bulbs are bad or they aren’t contacting with the lamp holders. With the turn off, make use of a screw driver to gently lift the bottom pin up a bit and then try your bulb again.

Read more related products:   Bakelite Light HolderHalogen light socket